User Tools

Site Tools


dell_t200_recept_printer_setup

This is an old revision of the document!


Installing a DELL T200 Receipt Printer

Windward Software

Problem Description

This document should be used if you are doing one of the following:

1)You are installing a DELL T200 receipt printer for the first time. or 2) You can not get the DELL T200 slip printer to cut or trigger cash drawer. or 3) The DELL T200 printer stops functioning and needs to be power cycled to get it to work.

Detailed Problem Solution

There may be other solutions to the issue, but this was the solution I used and it worked on each computer I set the printer up on. The first thing is to not install the DELL driver. If you have already installed it, don't panic. just uninstall the driver and continue on to the step below.

Set the driver in windows to Generic Text Only, and in the Printer commands tab, click in the End Print Job field and type <07> and click Apply and ok. In system Five, go to Setup Tools, Printer Setup, select the Generic / Text Only printer, set it to Slip Printer, and the Fast Dot Matrix will be automatically selected. Then in the Select Printer Codes drop down select 8 | Slip Printer. Then select the Printer Codes tab, and make sure it also is set to 8 | Slip Printer. Select 1 RESET, and in the white box at the botom of the window enter ESC “?” LF NUL Select 18 FORMFEED, and in the white box at the botom of the window enter ESC “d” 0 Select 19 CASH DRAWER 1, and in the white box at the botom of the window enter BEL Exit and then exit System Five Restart System Five and make sure that the Generic / Text Only printer driver is attached to the invoice form.

Steve Wind August 9/2010
dell_t200_recept_printer_setup.1281391302.txt.gz · Last modified: 2010/08/09 15:01 (14 years ago) by swind