faq:programming_a_symbol_stb4278_barcode_scanner
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
faq:programming_a_symbol_stb4278_barcode_scanner [2020/05/05 12:24 (4 years ago)] – created swind | faq:programming_a_symbol_stb4278_barcode_scanner [2021/05/27 13:57 (3 years ago)] (current) – swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Symbol STB4278 ===== | + | ====== Symbol STB4278 |
+ | \\ | ||
+ | <note important> | ||
+ | </ | ||
- | This Barcode Scanner model is a subset of the LS4278.\\ | ||
We have tested it with the programming sheets for the LS2208 and the following instructions will work to program it. | We have tested it with the programming sheets for the LS2208 and the following instructions will work to program it. | ||
- | **To program the scanner to accept both a prefix and suffix** | + | **To program the scanner to accept both an STX prefix and Carriage Return |
1) Scan the Scan options Barcode | 1) Scan the Scan options Barcode | ||
{{faq: | {{faq: | ||
Line 47: | Line 50: | ||
{{ : | {{ : | ||
+ | |||
+ | \\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | To test that the STX Prefix (Ctrl+B) has been programmed successfully, | ||
+ | You should see something like this: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | What you are looking for is that the scanner scanned a ^B before the barcode and it translates to a little smiley face character on the next line. | ||
+ | If this is what you see, you have correctly programmed the barcode scanner. | ||
+ | |||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | If you are running Windows 10 and still do not get the ^B character, you will need to run the command prompt as an administrator on the local workstation, | ||
+ | |||
+ | * Click Search or right click on the Windows button on the task bar and select Search. | ||
+ | * Type cmd. Command Prompt should show at the top of the search window. | ||
+ | * Right click on Command Prompt and select run as administrator. | ||
+ | * Right click on the top of the command prompt window where it says Administrator: | ||
+ | * On the bottom of the Command Prompt Properties window, check the checkbox that says Use legacy console (requires relaunch). | ||
+ | * Click OK and then close the command prompt window. | ||
+ | * Relaunch the command prompt and scan a barcode. You should now see the ^B | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | |||
+ | |||
+ | Created by Steve Wind May 5 2020 \\ | ||
+ | ====== |
faq/programming_a_symbol_stb4278_barcode_scanner.1588706678.txt.gz · Last modified: 2020/05/05 12:24 (4 years ago) by swind