faq:scanners:metrologic_series
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
faq:scanners:metrologic_series [2007/03/20 17:01 (17 years ago)] – Spelling error lawrence | faq:scanners:metrologic_series [2021/04/19 20:59 (3 years ago)] (current) – [MetroLogic Barcode Scanners] kturner | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== MetroLogic Barcode Scanners ====== | ====== MetroLogic Barcode Scanners ====== | ||
Metrologic makes a series of very popular scanners. | Metrologic makes a series of very popular scanners. | ||
+ | |||
+ | [[https:// | ||
==== Problem ==== | ==== Problem ==== | ||
Line 10: | Line 12: | ||
By scanning the barcodes below, you can program your MetroLogic scanner to provide a standard prefix in front of the barcode. | By scanning the barcodes below, you can program your MetroLogic scanner to provide a standard prefix in front of the barcode. | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
==== The Solution ==== | ==== The Solution ==== | ||
Scan the following codes, in order from start to finish, to add an STX prefix to all scanned codes. | Scan the following codes, in order from start to finish, to add an STX prefix to all scanned codes. | ||
+ | |||
+ | === Note === | ||
+ | For most of the Metrologic Brands of scanners, you may just need to scan the " | ||
+ | |||
+ | {{faq: | ||
+ | |||
+ | {{faq: | ||
+ | |||
<note important> | <note important> | ||
Line 18: | Line 36: | ||
<note warning> | <note warning> | ||
- | ==== The Codes ==== | + | ===== The Codes ===== \\ |
+ | These codes will work for the Honeywell Orbit MS7120 \\ | ||
^ Command ^ Scan Code ^ | ^ Command ^ Scan Code ^ | ||
- | ^ Enter Config | + | ^ Enter Config |
- | ^ Set Prefix | + | ^ Set Prefix |
- | ^ ASCII 0 | {{ http:// | + | ^ ASCII 0 | {{ :barcodescan: |
- | ^ ASCII 0 | {{ http:// | + | ^ ASCII 0 | {{ :barcodescan: |
- | ^ ASCII 2 | {{ http:// | + | ^ ASCII 2 | {{ :barcodescan: |
- | ^ End Config | + | ^ End Config |
+ | |||
+ | ======******====== | ||
+ | |||
+ | If neither of these codes allow you to set the Ctrl+B (STX Prefix), then download the programming manual here: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Once you have it, you will need to print out the Start/End Config barcode on the Introduction page, as well as the STX Prefix barcode on page 8-4 (page 46 of 116). Make sure that when you print these two pages, that you print them at the Actual size. You can not resize the pages, of have it fit to page, because that will alter the size of the barcode and it will not be scanable. | ||
faq/scanners/metrologic_series.1174435287.txt.gz · Last modified: 2007/03/20 17:01 (17 years ago) by lawrence