isc250_configuration
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
isc250_configuration [2018/11/09 11:35 (5 years ago)] – swind | isc250_configuration [2021/05/11 12:02 (3 years ago)] (current) – tanya | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Ingenico ISC 250 ====== ==== UNDER CONSTRUCTION ==== | + | ====== Ingenico ISC 250 ====== |
+ | ==== UNDER CONSTRUCTION ==== | ||
- | [[http:// | ||
- | ====== | + | ====== |
{{:: | {{:: | ||
Line 9: | Line 9: | ||
====== Configuration Over Terminal Services ====== | ====== Configuration Over Terminal Services ====== | ||
- | Recommended setup is using TCPIP | + | ===== Recommended setup is using TCPIP if supported by the payment processor ===== |
This is the simplest method as well because it doesn' | This is the simplest method as well because it doesn' | ||
+ | The device must be end-to-end encrypted so this will not work for most. | ||
First you will need to configure the pin pad for TCPIP. To do this, refer to the following document. | First you will need to configure the pin pad for TCPIP. To do this, refer to the following document. | ||
Line 17: | Line 18: | ||
https:// | https:// | ||
- | once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard. | + | Once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard. You will need to set the device for fixed ip in your router. |
Even though you will not be using a COM port to communicate with the pin pad, the DSI Client software requires one to be selected. If you do not select one you will get an error saying " | Even though you will not be using a COM port to communicate with the pin pad, the DSI Client software requires one to be selected. If you do not select one you will get an error saying " | ||
+ | ===== When TCPIP isn't supported by Payment processor ===== | ||
+ | |||
+ | Recommendation is to use the Remote POS Device Manager. This is what it was designed for. | ||
+ | |||
+ | http:// | ||
+ | |||
+ | |||
+ | Don't use port forwarding or COM Port redirection. This is highly problematic, | ||
- | ---- | + | ===== Configure pinpad from USB-Serial Mode ===== |
+ | |||
+ | http:// | ||
Created by Steve Wind November 9 2018 | Created by Steve Wind November 9 2018 | ||
- | ====== | + | |
- | [[http:// | + |
isc250_configuration.1541792125.txt.gz · Last modified: 2018/11/09 11:35 (5 years ago) by swind