User Tools

Site Tools


paymentech_pinpads

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
paymentech_pinpads [2019/05/13 16:25 (5 years ago)] – [verifone Vx820 Contactless] craigpaymentech_pinpads [2021/08/30 16:12 (3 years ago)] (current) plagrada
Line 1: Line 1:
 ====== Supported Paymentech™ Canada PINPads ====== ====== Supported Paymentech™ Canada PINPads ======
- +https://newaccount1608055419986.freshdesk.com/a/solutions/articles/66000494394
- +
-===== verifone Vx820 Contactless===== +
-  * This device is now available the Chase Paymentech. +
-  * EMV Contact and Contactless supported for the following card brands +
-     * Visa +
-     * Mastercard +
-     * Amex +
-     * Interac +
-     * JCB +
-  * Requires  +
-     * Vx820 XPI 12.08.16 +
-     * Netepay 5.06.10 +
-     * DSIEMVClientX® 1.27 +
-     * SystemFive version 6.2.2.262 or higher to support manual entry with CVV  +
- +
-<note warning>The Canadian VX810/820 pinpads are **RS-232 Serial only**. You need 9 PIN RS-232 Serial port on the back of your computer. **USB-Serial converters DO NOT WORK. I repeat, they DO NOT WORK**. They are also expensive for ones that may work. If you do not have a serial card, you can have one installed. The Edge USB-Serial converter is the only known one that works, but please don't waist your money and time on it when a serial port card can be installed for a third of the cost.</note> +
- +
- +
-===== verifone Vx810 ===== +
-  * Supports EMV Chip and PIN +
-  * Not suitable for large volumnes mail order ecommerce, use the legacy version below. +
-  * Requires System Five version 6.0.70.14 +
- +
-{{faq:payment_processing_setup:vx810.jpg|}} +
- +
-<note important>This version will no longer support manual entries of card numbers as Chase now requires the CVV number</note> +
- +
- +
- +
  
 ===== Other information ===== ===== Other information =====
paymentech_pinpads.1557789957.txt.gz · Last modified: 2019/05/13 16:25 (5 years ago) by craig