System Five Add-Ons & Integrations help simplify the way you do things.
Our catalog of services has topic-based, role-based, or technical plans that can help you maximize your software investment.
Copyright © 1984-present
Windward Software Systems Inc.
All Rights Reserved.
Privacy Policy
- Scans Popular 1D and 2D Barcodes - Data Collect 295ft (90m) from Base - 30,000+ Continuous Scans on One Full Charge - Durable 6.6ft (2m) Drop Spec and IP65 Rating - Green Spot Technology for Good-Read Feedback
The full programming manual can be downloaded from this link wasp-wdi7500-wws750-prg.pdf Or directly from Wasp's web site. http://dl.waspbarcode.com/kb/scanner/Wasp-WDI7500-WWS750-PRG.pdf
Print the following PDF and follow the instructions on that page.
stx_prefix.pdf
To test that the STX Prefix (Ctrl+B) has been programmed successfully, Drop to a command prompt and scan a barcode (NOT one of the ones from the programming sheets) You should see something like this:
What you are looking for is that the scanner scanned a ^B before the barcode and it translates to a little smiley face character on the next line. If this is what you see, you have correctly programmed the barcode scanner.
If you are running Windows 10 and still do not get the ^B character, you will need to run the command prompt as an administrator on the local workstation, and on the remote session, then check the properties of the command prompt.
There are a couple options that can be enabled if the scanner appears to be dropping barcodes. From what I have seen, this occurs when the barcode scanner or the cradle loses communication with one-another.
Good Read: When to Indicate - Page 68 Specifies when the reader will provide an indication (beep and/or flash its green LED), upon successfully reading a barcode. the default setting is “Indicate Good Read = After Decode”. This means that the handheld will beep when it scans a valid barcode. This will work in most instances.
If you are experiencing disconnects between the scanner and the cradle, you can change that setting to “Indicate Good Read = After Transmit”. This means it will wait to beep until after the scanner has sent the barcode to the cradle.
Batch Mode - Page 208 This option specifies whether or not to store labels in the handheld while disconnected from the cradle. By default batch mode is Disabled. this means the handheld will not store/batch labels. It will send the barcodes one at a time. If communication is lost between the scanner and cradle, the barcode will be lost. A better option would be to change this setting to Automatic. By doing this the scanner will store the barcodes within itself when it goes out of range and is disconnected from the cradle. This would also help eliminate missed scans
Bluetooth Reconnect Attempt Mode - Page 224 Enable/Disable reconnection by trigger pull. This is already enabled by default, but I am listing it here because it works with the batch mode setting above. With this enabled, if a barcode is stored in the barcode scanner but it couldn't communicate with the cradle, the next time you pull the trigger, it will re-attempt to send the stored barcode(s) to the cradle.