User Tools

Site Tools


wasp_wws750_barcode_scanner

This is an old revision of the document!


Wasp WWS750 Barcode Scanner

Windward Software

Overview

Details

Solution

Good Read: When to Indicate Page 68
Specifies when the reader will provide indication (beep and/or flash its green LED) upon successfully reading a barcode.
Default is Indicate Good Read = After Decode
Change to Indicate Good Read = After Transmit

Batch Mode Page 208
This option specifies whether to store labels in the handheld while discon­nected from the base.
Options are as follows:
Default is Disabled - The handheld will not store/batch labels.
Change to Automatic - The handheld will store labels to RAM when the handheld goes out of range and is disconnected from the remote device.
Jude will change this and test. This would also help eliminate missed scans

Bluetooth Reconnect Attempt Mode Page 224
Enable/Disable reconnection by trigger pull. Already enabled.

Steve Wind - January 28, 2021
wasp_wws750_barcode_scanner.1611864959.txt.gz · Last modified: 2021/01/28 12:15 (3 years ago) by swind