wasp_wws750_barcode_scanner
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
wasp_wws750_barcode_scanner [2021/01/28 12:48 (3 years ago)] – swind | wasp_wws750_barcode_scanner [2021/07/15 09:24 (3 years ago)] (current) – swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Wasp WWS750 Barcode Scanner ====== | ====== Wasp WWS750 Barcode Scanner ====== | ||
- | [[http:// | + | <note important> |
+ | </note> | ||
{{ : | {{ : | ||
Line 21: | Line 23: | ||
http:// | http:// | ||
- | ====== | + | ====== |
+ | |||
+ | Print the following PDF and follow the instructions on that page. | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | To test that the STX Prefix (Ctrl+B) has been programmed successfully, | ||
+ | You should see something like this: | ||
+ | |||
+ | {{dos1.jpg|}} | ||
+ | |||
+ | What you are looking for is that the scanner scanned a ^B before the barcode and it translates to a little smiley face character on the next line. | ||
+ | If this is what you see, you have correctly programmed the barcode scanner. | ||
+ | |||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | If you are running Windows 10 and still do not get the ^B character, you will need to run the command prompt as an administrator on the local workstation, | ||
+ | |||
+ | * Click Search or right click on the Windows button on the task bar and select Search. | ||
+ | * Type cmd. Command Prompt should show at the top of the search window. | ||
+ | * Right click on Command Prompt and select run as administrator. | ||
+ | * Right click on the top of the command prompt window where it says Administrator: | ||
+ | * On the bottom of the Command Prompt Properties window, check the checkbox that says Use legacy console (requires relaunch). | ||
+ | * Click OK and then close the command prompt window. | ||
+ | * Relaunch the command prompt and scan a barcode. You should now see the ^B | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ====== Optional Programming | ||
There are a couple options that can be enabled if the scanner appears to be dropping barcodes. From what I have seen, this occurs when the barcode scanner or the cradle loses communication with one-another. \\ | There are a couple options that can be enabled if the scanner appears to be dropping barcodes. From what I have seen, this occurs when the barcode scanner or the cradle loses communication with one-another. \\ | ||
Line 50: | Line 90: | ||
{{ : | {{ : | ||
+ | \\ | ||
+ | \\ | ||
Line 56: | Line 98: | ||
== Steve Wind - January 28, 2021 == | == Steve Wind - January 28, 2021 == | ||
+ | == Updated July 14, 2021 == |
wasp_wws750_barcode_scanner.1611866917.txt.gz · Last modified: 2021/01/28 12:48 (3 years ago) by swind